Talk Composites - The Forum for Advanced Composites
Advanced Composites Forum
Please note, following spam posts in our forums, all users must have a
If you can't see the New Topic button
then please ensure the email address on your account is verified.
Subscribe to forum
Goto Parent Forum
Flat board vacuum infusion, air voids
How much ink to use
Poor B side surface on vac infused part
Infusion chopped strand fibres
Silicone connector help please
Motorcycle Fuel Tank Carbon Fiber Help
Adhesive Use Between Layers
Infusion Stack advice please
Infusion resin for fiberglass?
Hardener past shelf life, can I infuse again?
Infusion tooling cause surface issues?
Where does the resin go ??
why does the bag loosen up when resin starts flowing???
things to look out for when making a car panel
Zero Leak Vacuum Infusion
Flow Media with Foam Core
GC-50 polyester gelcoat
How to get a show quality part????
Is this the same as tubing sold at composite suppliers?
Releasing part from mould issue
Viewing This Forum
InstantForum 2017-0 Final © 2021
Execution: 0.000. 7 queries. Compression Enabled.
Resend Validation Email