Talk Composites - The Forum for Advanced Composites
Advanced Composites Forum
Please note, following spam posts in our forums, all users must have a
If you can't see the New Topic button
then please ensure the email address on your account is verified.
Subscribe to forum
Goto Parent Forum
What material to use to make cores?
bubbles in infusion edges... mould involved?
Which Vacuum Gauge
What is acceptable leak rate for infusion?
Lantor Soric + flow mesh - any bad?
Elevating temperature during resin infusion curing process
Pre-made vacuum bags for food - an alternative to Vacuum bag film and tacky tape for infusion?
Carbon Fiber Plate - 2 Side Glossy Finish
Questions on mold temperature maximum and curing temperature maximum
Envelope vacuum bagging question
Relationship between resin temperature and viscosity
XCR™ Epoxy Coating Resin as infusion gelcoat
MTI hose question
Perplexed, just don’t understand?
Wax with spray glue will it work?
Chopped carbon fiber, vacuum bagging?
Maximun fabric thickness for infusion
A couple of questions relating to resin infusion setup
Viewing This Forum
InstantForum 2017-0 Final © 2020
Execution: 0.000. 4 queries. Compression Enabled.
Resend Validation Email