Talk Composites - The Forum for Advanced Composites
Advanced Composites Forum
Please note, following spam posts in our forums, all users must have a
If you can't see the New Topic button
then please ensure the email address on your account is verified.
Subscribe to forum
Goto Parent Forum
Skateboard foamcore infusion with glossy sides top and bottom
Surface finish on complicated part
Breather layer cloth?
Using a silicone foot mould for vacuum resin infusion
Preparing Test Sample
2k clear in mould before infusing
Breaking in mould. Does anyone do it? My moulds stuck!
After 3 fails its time to ask where i go wrong..
Mixed results with infusion, question about not using peel ply, and the potential finish
Weave a bit gappy
infusion with foam core
Heating aluminium mould before and after vacuum infusion
Large Tube - Closed split mould
Squeezee and Squeezer clamps fakes
Complex tubes - Closed Split mould
First Attempt - Results Question
Bubbling at the end of the degas
Carbon Fibre Wing Mirrors
Coating before resin infusion
Viewing This Forum
InstantForum 2017-0 Final © 2021
Execution: 0.000. 7 queries. Compression Enabled.
Resend Validation Email