New to infusion and dropped into the deep end.

Author	Message
ConfusionExpert	C ConfusionExpert posted 6 Years Ago HOT Topic Details
C Group: Forum Members Posts: 3, Visits: 17	Hello all, Long story short our "Infusion expert" clearly lied on his CV and has not got a clue what he's doing so my company let him go. Now I'm being thrown into the deep end because I've done prepreg and therefore have experience ... I have done very little infusion work and majority of it has been on smaller pieces. Im being tasked now to make a 15mm E-Plate which is 2500mm x 1200mm. The material is all 1200g Quad weave fibreglass. The layout on the table so far is: Peel ply 15x 1200g QUAD Peel ply Release film. Im not sure what would be the best way of infusing it. Any help would be greatly appreciated. Thanks in advance!
	Reply Like 3
Replies
scottracing	scottracing posted 6 Years Ago HOT Post Details
Group: Forum Members Posts: 460, Visits: 5.2K	why have you got peel ply on both sides?
	Reply Like 2
ConfusionExpert	C ConfusionExpert posted 6 Years Ago HOT Post Details
C Group: Forum Members Posts: 3, Visits: 17	+x scottracing - 3/5/2019 6:37:54 PM why have you got peel ply on both sides? This is the way I was taught to do it. Why?
	Reply Like 3