Hello all,

Long story short our "Infusion expert" clearly lied on his CV and has not got a clue what he's doing so my company let him go. Now I'm being thrown into the deep end because I've done prepreg and therefore have experience ... I have done very little infusion work and majority of it has been on smaller pieces.

Im being tasked now to make a 15mm E-Plate which is 2500mm x 1200mm. The material is all 1200g Quad weave fibreglass.

The layout on the table so far is:
Peel ply
15x 1200g QUAD
Peel ply
Release film. 

Im not sure what would be the best way of infusing it. Any help would be greatly appreciated. 

Thanks in advance!