Hello,

I recently purchased a panel of your 4.8 mm Nomex honeycomb, thickness 10 mm. I have a project where I need to bend a strip of the honeycomb about 5 cm wide into a cylinder and glue it on the inside of a tube with a radius of 100 mm. What happens is that the honeycomb gets warped (picture attached) and I could only glue it on the edges. Does anybody have any advice how to solve that? Is this a characteristic of this particular honeycomb or do all behave like that?

Yes that link is a good one to look at.   For mild curves, generally vacuum bagging will hold the material in place enough during the curing process of the resin film or resin adhesive. 

Warren Penalver
Easy Composites / Carbon Mods - Technical Support Assistant