How would you take a mould from this?


How would you take a mould from this?
View
Options
Author
Message
doormatt
doormatt
doormatt
posted 10 Years Ago HOT
Forum Member (31 reputation)Forum Member (31 reputation)Forum Member (31 reputation)Forum Member (31 reputation)Forum Member (31 reputation)Forum Member (31 reputation)Forum Member (31 reputation)Forum Member (31 reputation)Forum Member (31 reputation)
Group: Forum Members
Posts: 5, Visits: 67
Hi all first post here so hope i'm not posting in the wrong section, i've got a part i want to take a mould of to make carbon fibre copies of it. As you can see it's quite an awkward shape, how would you lot take a mould? 2 piece split mould if so would you go down the middle? 

 http://www.talkcomposites.com/Uploads/Images/146de6ac-7cbb-4916-b479-bf8f.JPG
http://www.talkcomposites.com/Uploads/Images/fd5c2160-c87a-4c25-9c84-89b8.JPG
Reply Like 3
Reply
doormatt
doormatt
doormatt
posted 10 Years Ago HOT
Forum Member (31 reputation)Forum Member (31 reputation)Forum Member (31 reputation)Forum Member (31 reputation)Forum Member (31 reputation)Forum Member (31 reputation)Forum Member (31 reputation)Forum Member (31 reputation)Forum Member (31 reputation)
Group: Forum Members
Posts: 5, Visits: 67
so if i get the epoxy mould making starter kit it should be fine as a 1 piece?
Reply Like 3
GO

Merge Selected

Merge into selected topic...



Merge into merge target...



Merge into a specific topic ID...



Submit

Threaded View
Threaded View
How would you take a mould from this?
doormatt - 10 Years Ago
     I'm not sure I see why it couldn't be a one piece mould...
Hanaldo - 10 Years Ago
     so if i get the epoxy mould making starter kit it should be fine as a 1 piece?
doormatt - 10 Years Ago
     Hanaldo is speaking as someone with expert knowledge and a lot of skill in mould making, forgive me...
VVS - 10 Years Ago
     i've got an order coming tomorrow, i'm going to try and do it as a one piece if i have no success...
doormatt - 10 Years Ago
     Ye give it a go should be ok if you are very careful with the edge/ off part of the mould, just be...
VVS - 10 Years Ago
     As above, just make sure that your flanges around the part flare outwards, so no danger of...
MarkMK - 10 Years Ago
     well it's all done and demoulded, not a complete success but i can see where i've gone wrong. If i...
doormatt - 10 Years Ago
     That's a shame, but at least not a ton of materials wasted What is the part by the way? At first...
MarkMK - 10 Years Ago
     it's a thumb grip off a steering wheel, thats my concern getting the carbon fibre to take to the...
doormatt - 10 Years Ago
     I'm certain that others with a bit more experience will offer up some good suggestions as and when...
MarkMK - 10 Years Ago
     It would be ok done with two pieces of fabric then put the cut down in the tight corner. you would...
VVS - 10 Years Ago

Similar Topics

Post Quoted Reply
Reading This Topic

Powered by InstantForum 2017-0 Final © 2025
Execution: 0.000. 3 queries. Compression Enabled.
Explore
Messages
Mentions
Search