this is the third part that comes out exactly the same and i've done 3 diff things so far.... my kitchen oven minum is 76c so i leave that 2 hours and then take it to 110c this time i added peelply on the edges but nothing... the stack is as fallowed  2 layers of pre-preg aviation no face side... ... eassycomposite unperforated release film and breather all over the mold put inside a bag and full vac... any ideas guys... this is dirving me crazy already 

Ramping up is not just increasing the temp by 20 degrees, it is linear increase of temperature, controlled at 2 degrees/min for example. You should build or buy a purpose built oven with a temperature controller. Also, you will need the correct out of autoclave pre-pregs, otherwise you will never get pinhole free parts outside of an autoclave.

cheers,

Good luck