Talk Composites - The Forum for Advanced Composites
Advanced Composites Forum
Please note, following spam posts in our forums, all users must have a
If you can't see the New Topic button
then please ensure the email address on your account is verified.
Subscribe to forum
Goto Parent Forum
Starting out with prepreg
Question about UV curing pre pregs : is it "mainstream" or not ?
Aluminum mold for prepreg
Resin Bleed Into Honeycomb
Scott bader gloss over xpreg xc110
Thin split-mould tube: how to make it faster & better inside quality?
Easy-Lease alternative for high-temp molds & XPREG or other prepreg systems.
XC130 + EG160 mould release problems
Soric infused mould for pre preg use?
Crack, pin holes or dry kind of surface occurring on the surface of CFRP sheet
Part comes out curved instead of being perfectly flat
Structural analysis ,material properties
XC110 and EB700, first use, not so great results, not sure what went wrong.
Flash tape and pre-preg
Pre-preg in Uni-mould
Carbon sticking to gelcoat
Mold Material For CFRP Prepregs for oven curing max(120 degree C)
Release Film Issue
request information on XC110 finishing problem
Viewing This Forum
InstantForum 2017-0 Final © 2023
Execution: 0.000. 4 queries. Compression Enabled.
Resend Validation Email