this is the third part that comes out exactly the same and i've done 3 diff things so far.... my kitchen oven minum is 76c so i leave that 2 hours and then take it to 110c this time i added peelply on the edges but nothing... the stack is as fallowed  2 layers of pre-preg aviation no face side... ... eassycomposite unperforated release film and breather all over the mold put inside a bag and full vac... any ideas guys... this is dirving me crazy already 

ok im running a second test on a second vac pump in my kitchen oven... this time i put the mold inside a carboard box that was filled with breather clotch and i place my wire tx term tip on the bottom side of the mold where it receives the heat and finaly got a stable  51.7