Ok here is a question, I would like to know if it is possible to lay (4) small molds is a casting box, using the resin infusion process for a parts run, end result (4) parts ready for finishing.

Now take in consideration that everything is done properly, gel coating, bagging, correct amount of resin etc.

could you elaborate please.

Agree with Carbon Tuner, I would make 4 molds rather than one. Especially if your parts are "deep", i would say making the bagging material conform to all curves would be tricky.

The downside of 4 molds would be the boring setup to do if you want to infuse all molds in once. Its 4 times the preparation time.

Cheers.

 



 


    A $1000 electronic device will always protect a 10 cents fuse