Non distructive bond seperation

Talk Composites - The Forum for Advanced Composites

Back

Non distructive bond seperation

Author	Message
f1rob	f1rob posted 7 Years Ago HOT Post Details
Group: Forum Members Posts: 237, Visits: 4.8K	The best way is heat and movement. If you can apply the heat to the inside of the meal tube so it transfers outwards to the glue before the carbon even better
	Reply Like 2
Warren (Staff)	Warren (Staff) posted 7 Years Ago ANSWER Post Details
Group: Administrators Posts: 2.5K, Visits: 8.5K	Unfortunately no off the shelf solvents will touch cured adhesive. Also The bond strength is typically higher than the interlaminar sheer strength of carbon fibre so ripping it apart is likely to lead to the carbon delaminating before the glue goes. If you have a reasonable bond gap, abrading away the adhesive is likely the best way. Warren Penalver Easy Composites / Carbon Mods - Technical Support Assistant
	Reply Like 4
Steve Broad	Steve Broad posted 7 Years Ago HOT Post Details
Group: Forum Members Posts: 408, Visits: 4.1K	+x Tony Corke - 10/26/2018 11:44:52 AM Hi, I want to seperate a fillament wound carbon tube from a steel bicycle frame that was bonded using Vuduglu Can this be done without cutting the tube or damaging the carbon tube or the steel frame? heat, acetone etc? Cheers Tony Googling this brings up many solvents, but readily available acetone is frequently mentioned. Try it on a test piece first. Edited 7 Years Ago by Steve Broad
	Reply Like 3
Tony Corke	Tony Corke posted 7 Years Ago HOT Topic Details
Group: Forum Members Posts: 1, Visits: 3	Hi, I want to seperate a fillament wound carbon tube from a steel bicycle frame that was bonded using Vuduglu Can this be done without cutting the tube or damaging the carbon tube or the steel frame? heat, acetone etc? Cheers Tony
	Reply Like 2