My first perfect straight from mould part

My first perfect straight from mould part - GC50 is fantastic!

Author	Message
jamesw	jamesw posted 12 Years Ago HOT Topic Details
Group: Forum Members Posts: 61, Visits: 558	My third infusion - and finally this one pulled straight from the mold and only needed a quick polish and trim to look like this! Spraying GC50 into the mould with the G100 gel spray gun has transformed my pieces (I was pinhole free on infusion 2 but was having carbon exposed at the surface) There has been a lot of discussion about problems brushing GC50 - I have to advise just getting the correct kit and spraying it... Edited 12 Years Ago by jamesw
	Reply Like 2
Reply
Jess8bit	Jess8bit posted 12 Years Ago HOT Post Details
Group: Forum Members Posts: 133, Visits: 566	Great Job James ! Could you share about the air compressor you used with the spray gun ? (model or spec if possible) I'm close to buy mine, but still hesitating about the tank volume (would 100 liters be enough for spraying a bonnet ?) thanks a lot J
	Reply Like 3

Merge into selected topic...

Merge into merge target...

Merge into a specific topic ID...

My first perfect straight from mould part - GC50 is fantastic!

jamesw - 12 Years Ago

wozza - 12 Years Ago

Jess8bit - 12 Years Ago

jamesw - 12 Years Ago

Thanxx for your quick answer :w00t:

Jess8bit - 12 Years Ago

wozza - 12 Years Ago

prsw - 12 Years Ago

Warren (Staff) - 12 Years Ago

ok, to bad. then I will hold on tight to the bottle I got. [quote][b]Warren (Staff)...

prsw - 12 Years Ago

jamesw - 12 Years Ago

Login
Remember Me Reset Password Resend Validation Email Login	Facebook Google