Hi guys!

Have been following you for many years and always been inspired by your YouTube tutorials!

I have a front splitter for my track car that I purchased not long ago and they don’t make it anymore so I’m wanting to make a mould of it incase it gets damaged but more to the fact I would like to make it out of carbon fibre.

It has many angles which means it can’t be made from a single piece mould, I was thinking a 2 piece split or even 3? consisting of a top and bottom so to speak

I would very much like your opinion and any advice you could give me in this venture, the splitter is in 2 parts and pictured is one one half as the other half is a mirror image.... also the aluminium plate bonded to the bottom will be removed For mould making

I have uploaded the pictures to my one drive via a link as o tried to upload the pictures straight to here but after 15mins of waiting it still hadn’t uploaded one picture.

https://1drv.ms/u/s!ApxzGlwLzg9QhTgOgj0AJpMaPCjM?e=sardGQ

Hope you can assist me
Thanks
Phil

Simple enough. Looks like it could be possible as a 2-piece, simply split along the middle of the radius of the leading edge. Might need 3, but from the quick look I had I don't see an obvious need for 3. 

Thank you for the reply, I’m hoping to make the part via resin infusion will the tight angle be an issue? I don’t have access to the oven to make the part from prepreg unfortunately

Thanks for the advice buddy! I think a 2 piece mould would be the way forward and I see what you mean about getting cloth in every section, wet lay and vaccum sounds a good idea I may have to try both techniques just to see what diffrence I get
I can see it’s going to be a task and a half! But I think with patience and lots and lots of practice it will look a nice item!
The part that stands vertical at the very front won’t be visible as it’s hidden by the numberplate but that doesn’t mean it can’t be a poor job, I’m hoping to have the underside lip reinforced with some Kevlar as it will get scraped badly with speed bumps.
Yes West Yorkshire Leeds area abit far to travel to Essex unfortunately but thanks for the offer

Infusion shouldnt be a problem. Little spray tack and this can be done without any major weave distortions (its quite easy for places where fingers fit).

If its really tricky gometry perhaps home made prepreg is the way to go