hi guys, ive finished making a large mould, however im not sure where would the best location to put the resin and vac pipes.
im planning to put a vac pipe on each side of the mould and resin feed in the middle, but im worried the resin might not be able to climb up a 1m long roughly 70degree slope on each side.

i have attached a picture to roughly illustrate the size of my mould.

would like some input on where would be the best locations to put resin feed and vac pipes

thanks

Gravity has very little effect on flow in resin infusion, so don't need to worry about that.

Central feed is normally the most efficient way, if you have somewhere to place it that won't effect the finished panel (the laminate underneath the resin inlet does not get consolidated, leaving it very resin rich which can then print through to the surface if the laminate is thin). 

Your mould isn't massive in terms of infusion, depending on how thick the laminate is you could infuse from one side to the other as well, it would just take much longer. Central feed would be my preference here too, and the way you have illustrated is fine.