By 8900120dd - 10/10/2019 2:14:59 PM
hi guys, ive finished making a large mould, however im not sure where would the best location to put the resin and vac pipes.
im planning to put a vac pipe on each side of the mould and resin feed in the middle, but im worried the resin might not be able to climb up a 1m long roughly 70degree slope on each side.
i have attached a picture to roughly illustrate the size of my mould.
would like some input on where would be the best locations to put resin feed and vac pipes 
thanks 
|
By Hanaldo - 10/12/2019 6:29:32 AM
Bang on Mark, I didn't even notice that measurement on the side and was imagining like a boat hull or something.
I'd go side to side exactly as Mark described if it is only 50cm across.
|
|