+x Matthieu Libeert - 12/31/2018 2:49:58 PM+x oekmont - 12/31/2018 5:22:52 AMNo, 1 component lacquer almost always makes trouble during demoulding. Almost as bad as body filler.Like Oekmont is saying, - any porous material is the start of disaster. Wood/mdf/foam/stone,... pockets to get your part stuck. - primers and body filler are made to grip on the next layer, in your case your part unfortunately, the idea of coating it with epoxy was good, but you probably still had some spots left that were not coated. - like above; if you wax, use at least 7 coats with buffing it of every 20min (when dry) PVA is ok but hard to get good results with, Easylease is your solution here. - Never use 1K, they are not made to be resistent to resins especialy not polyester resin as the styrene in the 1k will chemicaly bond to your polyester.How to solve your problems if you are not able to spray a full coat of 2K clear/paint;Watch the youtube tutorial of EC using the pattern primer and pattern gloss coat. This will seal your mould and you'll be able to sand it easily and get a nice full seal. (let it all cure for 5 days idealy)Then easylease 7 times and try again
+x oekmont - 12/31/2018 5:22:52 AMNo, 1 component lacquer almost always makes trouble during demoulding. Almost as bad as body filler.