Hi Joe,

Fantastic helmet!!! Way cooler than your average bit of kit...

Hi,

Thx guys for your nice comments.

@prairiecustoms: the band was cut to width, then I removed the outer 3k carbon tow (lengthwise, both sides of course). It's then tacked in place with masking tape wraped to become double side in the area of the mold where is the welding lens opening recess (dunno if it makes sense). I do not have tack spray so thats the only way I found to "secure" it relative to the mold. The ends of the band are secured to the mold flanges the same way.

For the rest, i just prayed the Composite God for the band not to move while laying the fabric layers. Seems I was lucky (but hey I prayed much).

 



 


    A $1000 electronic device will always protect a 10 cents fuse

nice work, looks great! did you use any varnish, topcoat on top? i'm finnishing my helmet these days

Matthieu Libeert
Founder MAT2 Composites X Sports
website: www.mat2composites.com

Hey Matthieu, nice to hear about you! The helmet has its "out of the mold" bare epoxy finish. Cant wait to see your goalie in this showroom thread

 



 


    A $1000 electronic device will always protect a 10 cents fuse

Made some side scoops for my car.  These are wet lay with a 200g outer layer for the nice pattern followed by 2 layers of 600g.





I also made some dash plates to replace the the manky silver ones which looked rather dated.

Quite cool

 



 


    A $1000 electronic device will always protect a 10 cents fuse

Hi guys, so I finished my projects a few days ago, that I've started 6 months ago  

Hi Matthieu. I'm glad you finally made it! Looks quite nice, but should I ask for some front side pictures?

 



 


    A $1000 electronic device will always protect a 10 cents fuse

Here are the additional pictures 

Haha, looks killer !

 



 


    A $1000 electronic device will always protect a 10 cents fuse