Plug issues

Talk Composites - The Forum for Advanced Composites

Back

Plug issues

Author	Message
ArturK	ArturK posted 9 Years Ago HOT Post Details
Group: Forum Members Posts: 19, Visits: 53	The problem can be: 1. Temperature at your workplace (most separators needs >25 C temperature during application) 2. Mould coating - do not know this products, but many standards coats react with release agents. Mould coating has to be fully cured of course (some products needs even 14 days after coating for full curing. 3. Release agent itself. Carbon fiber sheets and composites . www.dexcraft.com
	Reply Like 4
*VVS*	*VVS* posted 9 Years Ago HOT Post Details
Group: Moderators Posts: 226, Visits: 334	i always leave the metal seal in the tin and make a small hole in one side so you only get a trickle coming out.
	Reply Like 4
Hanaldo	Hanaldo posted 9 Years Ago HOT Post Details
Group: Forum Members Posts: 2.5K, Visits: 28K	It sounds like this was definitely a release failure. How well did you clean the plug before applying it, did you use a solvent? How well sealed have you kept the bottle of Easylease? When you are applying it, do you keep the lid off or do you put the lid back on straight away before applying it to the mould? Chemical release agents are very sensitive to moisture and are hygroscopic by nature, so you need to be quite careful with how well sealed you keep the bottle and how often you expose it to the air.
	Reply Like 4
67redrocket	67redrocket posted 9 Years Ago HOT Post Details
Group: Forum Members Posts: 49, Visits: 486	Yes I used a 8 month old easy lease. Applyed it with a cloth six times like I always do. 15 minutes between each and 1 hour before first layer of gel coat. Yes i had some trouble releasing it.
	Reply Like 4
Hanaldo	Hanaldo posted 9 Years Ago HOT Post Details
Group: Forum Members Posts: 2.5K, Visits: 28K	Looks like a release problem. I assume you are using Easylease? How did you apply it, how old is it? Often stress cracks like this are caused when there is a partial release failure, so it hasn't completely stuck but it takes too much force to demould. The bits of stuck gelcoat also tell me this was the case.
	Reply Like 3
67redrocket	67redrocket posted 9 Years Ago HOT Topic Details
Group: Forum Members Posts: 49, Visits: 486	I made a unimold of a plug today. The plug got bad and also the mold. Does anyone know what can have caused these problems? I have use both the pattern coat primer and the hi gloss on a MDF pattern.
	Reply Like 3