http://www.ebay.com.au/itm/201425740216?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT




Had a real hard time removing flow media and peel ply from a fairly complex mould. Do you think this perforated release film would be ok between the flow media and the peel ply ?

perforations are 0.8mm or  .031"   at 5mm spacing




Thanks




Rod.

Your probably right bud , I just thought I could get a more reliable seal on a nice flat surface rather than wrinkly vac bag.  I have sanded the aft sides nice and smooth and flat where the tubes go through.

I use  flanged bush which slides over the tube and sealed with a tack tape doughnut against the mould.