Bending cured pepreg

Talk Composites - The Forum for Advanced Composites

Back

Bending cured pepreg

Author	Message
Steve Broad	Steve Broad posted 5 Years Ago HOT Post Details
Group: Forum Members Posts: 408, Visits: 4.1K	+x Hanaldo - 6/8/2020 12:01:29 AM Yeh I've done this before for patching holes in bodywork on panels with slight curvature. Just be aware that it does actually stress the carbon and make it quite weak. I am surprised that it has that much of a weakening effect. However, this was going to be used to adjust a door shut line so that wouldn't be an issue.
	Reply Like 6
Hanaldo	Hanaldo posted 5 Years Ago HOT Post Details
Group: Forum Members Posts: 2.5K, Visits: 28K	Yeh I've done this before for patching holes in bodywork on panels with slight curvature. Just be aware that it does actually stress the carbon and make it quite weak.
	Reply Like 6
Steve Broad	Steve Broad posted 5 Years Ago HOT Post Details
Group: Forum Members Posts: 408, Visits: 4.1K	+x Chris Rogers - 6/7/2020 4:26:07 PM Ok, that's interesting. Why does it do that? Is the heat you're applying above the HDT of the pre-preg? What resin system? I think I have just copied what happens when non post cured carbon is left out in the sun, it sags as it post cures. I twisted the carbon, held it in place and heated it with a hot air gun to around 130deg C for 10 minutes then let it cool overnight. Not sure what the HDT is as it isn't stated on the data sheet: https://shdcomposites.com/admin/resources/mtc510-tds.pdf
	Reply Like 4
Chris Rogers	C Chris Rogers posted 5 Years Ago HOT Post Details
C Group: Forum Members Posts: 120, Visits: 933	Ok, that's interesting. Why does it do that? Is the heat you're applying above the HDT of the pre-preg? What resin system?
	Reply Like 6
Steve Broad	Steve Broad posted 5 Years Ago HOT Topic Details
Group: Forum Members Posts: 408, Visits: 4.1K	This may be of interest to someone :-) Edited 5 Years Ago by Steve Broad
	Reply Like 6