That looks excellent , did you use infusion Warren ?

Chris

Managed to get the prototype duct finished.

Carbon Copies Ltd

Managed to get the plug done for the top section of the Duct which will house the cone filter. The CFD simulation indicates a decent "Ram Air" effect but only a session on the dyno will see if there is any increase in Horse Power. 

Carbon Copies Ltd

Thanks for the comments chaps. I managed to pull a GRP test piece today just to prove the mould. The duct is for a customer who wanted a specific size Intake Duct. 300mm x 220mm to take 75mm Ducting.

It looks good so far. That part looks like the duct used on NASCAR windows.

Looking good!  Your own variation of the NACA duct I guess.

Warren Penalver
Easy Composites / Carbon Mods - Technical Support Assistant

Another weekend spent shaping foam and sanding body filler!! A good few coats of high build primer. A flat and polish tomorrow and should be able to take a mould from it.