XCR™ Epoxy Coating Resin as infusion gelcoat


XCR™ Epoxy Coating Resin as infusion gelcoat
View
Options
Author
Message
torsten Ker
t
torsten Ker
posted 5 Years Ago HOT
Supreme Being (629 reputation)Supreme Being (629 reputation)Supreme Being (629 reputation)Supreme Being (629 reputation)Supreme Being (629 reputation)Supreme Being (629 reputation)Supreme Being (629 reputation)Supreme Being (629 reputation)Supreme Being (629 reputation)
Group: Forum Members
Posts: 59, Visits: 278
Hi
I wonder  if the XRC could be uses as a gelcoat in a mould as a replacment of the GC50 polyester
thanks
T
Reply Like 5
Reply
torsten Ker
t
torsten Ker
posted 5 Years Ago HOT
Supreme Being (629 reputation)Supreme Being (629 reputation)Supreme Being (629 reputation)Supreme Being (629 reputation)Supreme Being (629 reputation)Supreme Being (629 reputation)Supreme Being (629 reputation)Supreme Being (629 reputation)Supreme Being (629 reputation)
Group: Forum Members
Posts: 59, Visits: 278
I didn't think about that,  testing it is
thanks
Reply Like 5
GO

Merge Selected

Merge into selected topic...



Merge into merge target...



Merge into a specific topic ID...



Submit

Threaded View
Threaded View
XCR™ Epoxy Coating Resin as infusion gelcoat
torstenker - 5 Years Ago
     Although it would be better than a typical lower viscosity laminating resin, it is still much thinner than a gelcoat so for anything other than relatively flat parts, it would likely run or fisheye.
Warren (Staff) - 5 Years Ago
     I didn't think about that, testing it is thanks
torstenker - 5 Years Ago

Similar Topics

Post Quoted Reply
Reading This Topic

Powered by InstantForum 2017-0 Final © 2025
Execution: 0.000. 3 queries. Compression Enabled.
Explore
Messages
Mentions
Search