Is this normal on mould surface?

Author	Message
Lester Populaire	L Lester Populaire posted 5 Years Ago HOT Post Details
L Group: Forum Members Posts: 311, Visits: 13K	Or stick some painters tape on there and it should peel off with the tape.
	Reply Like 7
f1rob	f1rob posted 5 Years Ago HOT Post Details
Group: Forum Members Posts: 237, Visits: 4.8K	just normal bleed out flash use a filler spreader or perspex scraper too get it off
	Reply Like 6
carbon man	carbon man posted 5 Years Ago HOT Topic Details
Group: Awaiting Activation Posts: 86, Visits: 1.2K	Is this normal. Every pull seems to add a bit more on. Its on the flange area where there is no carbon laid. But leaves residue of resin. Some flakes off but a lot sticks on? I put release film over the whole mould surface.
	Reply Like 5