Skinning raw metal

Talk Composites - The Forum for Advanced Composites

Back

Skinning raw metal

Author	Message
marc37i	marc37i posted 13 Years Ago HOT Post Details
Group: Forum Members Posts: 16, Visits: 566	Matt (Staff) (04/12/2012) Hi Marc, The bond would be better to bare, keyed, metal than it would to the plastic of the paint. Likewise, I would say that the bond of the epoxy to the metal would also be better than the bond of the paint to the metal too so if you have a choice then bare metal is the way to go. --Matt Thanks Matt :-)
	Reply Like 5
Matt (Staff)	Matt (Staff) posted 13 Years Ago HOT Post Details
Group: Forum Members Posts: 680, Visits: 1.9K	Hi Marc, The bond would be better to bare, keyed, metal than it would to the plastic of the paint. Likewise, I would say that the bond of the epoxy to the metal would also be better than the bond of the paint to the metal too so if you have a choice then bare metal is the way to go. --Matt Matt Statham Easy Composites / Carbon Mods - Technical Sales
	Reply Like 6
marc37i	marc37i posted 13 Years Ago HOT Post Details
Group: Forum Members Posts: 16, Visits: 566	Matt (Staff) (03/12/2012) Hi Pedro, No, you should be fine to apply the skin of carbon fibre direct to the metal; in fact the epoxy should act as a primer, ensuring that water cannot reach it. Ensure that there are no areas that are not covered by the resin otherwise these may be a point where corrosion could start but providing the metalwork is completely covered in the epoxy (used for the carbon skin) you should be fine. Best regards, Matt Hi Matt, That was good timing because I was wondering about this too. Would you say it was better to apply the carbon to bare metal or if the metal panel was already painted would it be ok to just key the surface and apply the carbon? Would the epoxy bond be greater to bare metal as opposed to the paint? Many Thanks Marc
	Reply Like 5
Matt (Staff)	Matt (Staff) posted 13 Years Ago HOT Post Details
Group: Forum Members Posts: 680, Visits: 1.9K	Hi Pedro, No, you should be fine to apply the skin of carbon fibre direct to the metal; in fact the epoxy should act as a primer, ensuring that water cannot reach it. Ensure that there are no areas that are not covered by the resin otherwise these may be a point where corrosion could start but providing the metalwork is completely covered in the epoxy (used for the carbon skin) you should be fine. Best regards, Matt Matt Statham Easy Composites / Carbon Mods - Technical Sales
	Reply Like 5
pedcrist	pedcrist posted 13 Years Ago HOT Topic Details
Group: Forum Members Posts: 42, Visits: 350	Hi I need to skin a motorcycle fender with cf, but it is in raw metal. Do i have to aplly some primer first, to prevent the appearence of rust? Pedro
	Reply Like 5