+x Matt (Staff) - 7/13/2018 8:38:07 AM+x Dinoman - 7/12/2018 10:45:05 PMHi I have been looking at this Air Box and trying to figure out how I can Vaccum Bag ??? to me looks impossible, so any help appreciated, Regards DMHi There,Actually, I think you might be overthinking it. Unless there's something I'm missing - I'm assuming that the bottom face which we can't see it completely open - The the bag would actually be very simple, it would just need to also be very large (like more than twice the size of the part). I can't see the mould so I don't know if you're planning to envelope bag or tape to the mould flange but the principle would be the same either way. If the bag was large enough you could just feed two 'socks' of bag into the inlet tubes and then would blank off at the mouth of the tubes (again, I can't see the mould but I assume the mould too blanks off at the mouth of these inlet tubes).As Steve has posted we also don't know what the rectangle is but I'm assuming it's just a cuboid shaped recess which is fully closed off, in which case you could just bag around this using the huge excesses of bag I'm suggesting again too.If you were envelope bagging then just imagine an absolutely massive bag with the part and mould inside and the bag sealed all around. When you do this you can picture yourself just stuffing bag into those two inlets (as though you'd fashioned some tube shapes from the big bag and fed them into these inlets) and then and the rest into the main area.I hope this helps but if I've missed something then let me know!
+x Dinoman - 7/12/2018 10:45:05 PMHi I have been looking at this Air Box and trying to figure out how I can Vaccum Bag ??? to me looks impossible, so any help appreciated, Regards DM