helloEveryone.

I havea problem with my last project.  I just cant get a decent finish on thislittle part.  Al the straight areas are fine, just can't get these cornersright. I tried a few other setups but this one last night was even the worse imade !!

usethese parts:

-2layers of carbon fibre

-alstuff that can be sold in this kit on easy comp webshop as consumables.

https://www.easycomposites.co.uk/vacuum-bagging-starter-kit

so peelply / perforated film / breatherlayer / bagging film is all easy comp.

The laminating resin EP-L2-F-5 is usedfrom Easy comp also.

Itlooks that the bag closes in this setup complete everytime, but like the picturesshow, i have places where the is no epoxy at al.

I madechanges to the setup like: extra breather layer as I suspected this could helpme close the gap between carbon and corners. I’m sure that there is enough epoxy as the breather has thebreather has excess resin when finished.

I wasthinking 2 extra layers of carbon could help me also but I first want to hearover here if there aren’t any other things I’m completely missing?