Skinning amine blush

Author	Message
thanasiss3	thanasiss3 posted 10 Years Ago HOT Topic Details
Group: Forum Members Posts: 18, Visits: 348	Hi everyone,i skin parts for automotive interiors with cf using the ec high temp epoxy resin,after the wrapping i wet the fabric with epoxy,after 24hours i sand with 120grit and after that add 2 layers of epoxy when the first is at tack free stage. After that i put the parts in an oven and ramp the temp at 100celcius,after that i have too much amine blush,it can stick to my hand,is this normal? Is there any chance the epoxy to keep blushing under the 2k clearcoat and give me a yellowish pary? I must wait more time to cure after the complete cycle at the oven?
	Reply Like 3
Reply
thanasiss3	thanasiss3 posted 10 Years Ago HOT Post Details
Group: Forum Members Posts: 18, Visits: 348	In greece under a hot summer day i measure 85 celcious into the car,it became extremely hot and the other clear resins i used,made a heavy print through,i post curedbthem but their tg was 60-70,so they became printed through. I post cure thw ht resin at 95celsious so the parts stay glass reflection alla the time! 'Low' tg resin Edited 10 Years Ago by thanasiss3
	Reply Like 3

Merge into selected topic...

Merge into merge target...

Merge into a specific topic ID...

thanasiss3 - 10 Years Ago

Dravis - 10 Years Ago

thanasiss3 - 10 Years Ago

Warren (Staff) - 10 Years Ago

VVS - 10 Years Ago

thanasiss3 - 10 Years Ago

Login
Remember Me Reset Password Resend Validation Email Login	Facebook Google