Hi Guys.
Just got a big package from EC, so time to get my hands dirty.

I want to start with this part





I figured the best would do to use the uni-mold system.
I have a plexiglass piece which im planning to use as the work surface.

Then im planning to cut some propylene sheet and use plasticine around the front part
Also since im using twaron and carbon im thinking about filling the profile with plasticine.. but on second thoughts that may not be neccessary



Does this look ok?
Im going to resin infuse it

Any other recommendations?

Thanks.
Its actually a air deflector that leads the air out from the radiator, the engine is in the back =)

I have just added the coupling coat.
I mixed 303g coupling gel and 5g of mekp on top in a plastic cup.
What happened was that firstly within 5-8minutes the bottom of the cup had hardened, and second the cup started dissolving =).
So i recon i need to use papercups and not plastic, but why did the gel harden so fast?

Didnt i mix the mekp rough enough maybe?