Hi all. I’d like to show you my lasts work about composites.

I’m  very found in Hydrofoil kiteboarding, so in the past 10 years I do some models

This is the last one. The idea was to build something different  from the models on the market, an hydrofoil easy, stable, and possibly fast.

 Some pictures:

In this video you can see the first trials.

https://www.youtube.com/watch?v=hP4AcEQYi5w

In this one the building process for the board.

https://www.youtube.com/watch?v=iWn100jdyY0

An old version

I hope you like

At this moment a new one is growing

My You Tube Channel

I just watched your video and read that you did a spoof of cutting out the designs with the knife so fast. But, is that the way you actually do it? with a sharp knife. I am wanting to do something like what you do on a coffee table of mine. Is it a sheet that is just one thickness and already cured or do you try to cut it out ahead of time. 

is that the way you actually do it? with a sharp knife.

Yes, but often I need also sanding a little bit the edge because cutting with a knife it's difficult to follow complex lines.

I'ts quite easy with the 160 gr spread tow, it's a little bit harder with the 200 gr spread tow.
I'm not sure that it's possible whith other fabrics

Is it a sheet that is just one thickness and already cured

Yes, you need hard and cured material.

My new work in progress, the fabric is already infused and cured







My You Tube Channel