Releasing part from mould issue


Releasing part from mould issue
View
Options
Author
Message
Classicarbon
C
Classicarbon
posted 6 Years Ago HOT
Supreme Being (768 reputation)Supreme Being (768 reputation)Supreme Being (768 reputation)Supreme Being (768 reputation)Supreme Being (768 reputation)Supreme Being (768 reputation)Supreme Being (768 reputation)Supreme Being (768 reputation)Supreme Being (768 reputation)
Group: Forum Members
Posts: 86, Visits: 639
Part come ok but I founding problems to find the place on edge of the part to lift it up. Should I apply more release agent between edge of the part and gum tape?
I used mould release only on.last one.
Reply Like 4
GO

Merge Selected

Merge into selected topic...



Merge into merge target...



Merge into a specific topic ID...



Submit

Threaded View
Threaded View
Releasing part from mould issue
Classicarbon - 6 Years Ago
     It can help a little. The edge of a fine scalpel or similar can often be used to lift the carbon edge enough to slide a thin demoulding wedge or similar underneath.
Warren (Staff) - 6 Years Ago
             Hello dear Warren, I'm planning to make a composite part of motorcycle using carbon fiber, which is wetting by gelcoat for the external interface and using infusion vacuum. After curing, I will add....
Yassine - 6 Years Ago

Similar Topics

Post Quoted Reply
Reading This Topic

Powered by InstantForum 2017-0 Final © 2025
Execution: 0.000. 3 queries. Compression Enabled.
Explore
Messages
Mentions
Search