Talk Composites - The Forum for Advanced Composites

Releasing part from mould issue

http://www.talkcomposites.com/Topic34059.aspx

By Classicarbon - 10/24/2019 7:52:55 PM

Part come ok but I founding problems to find the place on edge of the part to lift it up. Should I apply more release agent between edge of the part and gum tape?
I used mould release only on.last one.
By Yassine - 11/4/2019 4:23:16 PM

 
Warren (Staff) - 10/25/2019 1:46:35 PM
It can help a little.  The edge of a fine scalpel or similar can often be used to lift the carbon edge enough to slide a thin demoulding wedge or similar underneath. 

Hello dear Warren,

I'm planning to make a composite part of motorcycle using carbon fiber, which is wetting by gelcoat for the external interface and using infusion vacuum. After curing, I will add additional layers used Fiberglass which is wetting by resin and using the Hand lay-up method.
Is it possible?

Kind regards
yassine