Releasing part from mould issue

Author	Message
Yassine CHBANI IDRISSI	Y Yassine CHBANI IDRISSI posted 6 Years Ago HOT Post Details
Y Group: Forum Members Posts: 4, Visits: 91	+x Warren (Staff) - 10/25/2019 1:46:35 PM It can help a little. The edge of a fine scalpel or similar can often be used to lift the carbon edge enough to slide a thin demoulding wedge or similar underneath. Hello dear Warren, I'm planning to make a composite part of motorcycle using carbon fiber, which is wetting by gelcoat for the external interface and using infusion vacuum. After curing, I will add additional layers used Fiberglass which is wetting by resin and using the Hand lay-up method. Is it possible? Kind regards yassine
	Reply Like 4
Warren (Staff)	Warren (Staff) posted 6 Years Ago HOT Post Details
Group: Administrators Posts: 2.5K, Visits: 8.5K	It can help a little. The edge of a fine scalpel or similar can often be used to lift the carbon edge enough to slide a thin demoulding wedge or similar underneath. Warren Penalver Easy Composites / Carbon Mods - Technical Support Assistant
	Reply Like 5
Classicarbon	C Classicarbon posted 6 Years Ago HOT Topic Details
C Group: Forum Members Posts: 86, Visits: 639	Part come ok but I founding problems to find the place on edge of the part to lift it up. Should I apply more release agent between edge of the part and gum tape? I used mould release only on.last one.
	Reply Like 4