Hi all

I am new to mould making at home and to this site

I have a Uni-Mould kit from Easy Composites and have made a pattern for a kit car scoop using my original scoop from the car see picture attached

I would really like any tips / advice you may have on how to prep / release the pattern before making the mould

I have read instructions sheets and watch videos BUT would welcome any contributions as you cannot beat the experience of other people that have started out the same way

For example I have a block of filleting wax to use where there might be some under cuts but do i put this on before or after releasing the pattern

Thanks in advance for any helping a newbie

Regards
Ian

I usually release/wax a mould first and then add any yellow wax filling or fillets etc.