Mass production?


Mass production?
View
Options
Author
Message
Darren
Darren
Darren
posted 11 Years Ago HOT
Supreme Being (406 reputation)Supreme Being (406 reputation)Supreme Being (406 reputation)Supreme Being (406 reputation)Supreme Being (406 reputation)Supreme Being (406 reputation)Supreme Being (406 reputation)Supreme Being (406 reputation)Supreme Being (406 reputation)
Group: Forum Members
Posts: 54, Visits: 916
something I've been working on the past week. its a brake master cylinder cover.
I need to produce a lot of these, i resin infused this one last night but took me around an hour and half. (I'm still new to all this)
What would be the easiest/quickest way? and keeping the cost down

Thanks
Reply Like 3
GO

Merge Selected

Merge into selected topic...



Merge into merge target...



Merge into a specific topic ID...



Submit

Threaded View
Threaded View
Mass production?
Darren - 11 Years Ago
     Practice, fast cure hardener and more moulds
ajb100 - 11 Years Ago
     exactly that. Try making a mould with 4 or 5 of those in a row. Infuse in one go with fast resin....
FLD - 11 Years Ago
             If possible try with wet-lay up and vacuumbag (takes less time to put everything down, but more...
matthieutje65 - 11 Years Ago
     The longest part for me is making all the pleats in the bag to make sure it gets sucked down to the...
Darren - 11 Years Ago
     The elastifilm isn't suitable for infusion, and I found it punctured far too easily. The easy way...
ajb100 - 11 Years Ago
     Is it possible to resin infuse with an envelope bag? Any improvements i can make to the mould before...
Darren - 11 Years Ago
     Pre preg is doable but it would likely quadruple your costs, you would need to use Uni mould, and...
ajb100 - 11 Years Ago
     Ok i know which way im going with this now ;) Another question, whats the best spray adhesive...
Darren - 11 Years Ago
     I use aerofix 2, a lot suggest 3m 77 but I find it hard to get and expensive
ajb100 - 11 Years Ago
             [quote][b]ajb100 (06/03/2014)[/b][hr]I use aerofix 2, a lot suggest 3m 77 but I find it hard to get...
Darren - 11 Years Ago
                 [quote][b]Darren (07/03/2014)[/b][hr][quote][b]ajb100 (06/03/2014)[/b][hr]I use aerofix 2, a lot...
ajb100 - 11 Years Ago
                     I use Aerofix2 as well and works perfect!
matthieutje65 - 11 Years Ago
     Hi you can produce the part with a silicon intisifire , heat the mold little bit every few minutes...
Gadi - 11 Years Ago

Similar Topics

Post Quoted Reply
Reading This Topic

Powered by InstantForum 2017-0 Final © 2025
Execution: 0.000. 2 queries. Compression Enabled.
Explore
Messages
Mentions
Search