Creating a 3 or 4 section boom using carbon fibre tubing.


Creating a 3 or 4 section boom using carbon fibre tubing.
View
Options
Author
Message
khalid
khalid
khalid
posted 12 Years Ago HOT
Junior Member (9 reputation)Junior Member (9 reputation)Junior Member (9 reputation)Junior Member (9 reputation)Junior Member (9 reputation)Junior Member (9 reputation)Junior Member (9 reputation)Junior Member (9 reputation)Junior Member (9 reputation)
Group: Forum Members
Posts: 1, Visits: 3
I am looking to create a 4x1.5m (6m total length approx) CF boom around 52mm OD.

Can you create 4 sections that can screw tight into one another to create this long pole?

 
Reply Like 4
GO

Merge Selected

Merge into selected topic...



Merge into merge target...



Merge into a specific topic ID...



Submit

Threaded View
Threaded View
Creating a 3 or 4 section boom using carbon fibre tubing.
khalid - 12 Years Ago
     We don't stock a tube in the size you mention but do have a couple either side of it. When making...
Warren (Staff) - 12 Years Ago
     Would it be better to use a cut length of 47.5 mm ID or 46mm ID to slide into a length of 50.8 mm ID...
mattv - 12 Years Ago
     47.5mm ID tube has a rough OD of 50.3mm so half a mm difference should be ok. If youre ordering from...
Warren (Staff) - 12 Years Ago
             Hi, I am looking at an application that requires a similar length of pole ,but has to be able to be...
Campbell - 12 Years Ago
                 hi, campbelll, we are able to provide customized tubes, please visit our website...
singcomposite - 11 Years Ago
     The overlap size depends on overall length, load, expected directions of stress etc. When bonded...
Warren (Staff) - 12 Years Ago
             The total length needs to 6mtr. It must be able to be broken down to allow for transportation , max...
Campbell - 12 Years Ago
     Id suggest a 6 inch overlap would be fine to start with but ultimately you would need to experiment...
Warren (Staff) - 12 Years Ago
     Hi, I'm looking to construct a camera pole using3 x 2.5m tubes togive me about 6m reach after...
Roy - 11 Years Ago
             Hi, Roy, we are able to provide customized rods and tubes. Please visit us at www.singcomposite.sg
singcomposite - 11 Years Ago
     Hi, khalid , you may take a look at our team, www.singcomposiate.sg. We have extensive experience in...
singcomposite - 11 Years Ago

Similar Topics

Post Quoted Reply
Reading This Topic

Powered by InstantForum 2017-0 Final © 2025
Execution: 0.000. 2 queries. Compression Enabled.
Explore
Messages
Mentions
Search