infusion surfboard


infusion surfboard
View
Options
Author
Message
demy182
d
demy182
posted 5 Years Ago HOT
Forum Member (31 reputation)Forum Member (31 reputation)Forum Member (31 reputation)Forum Member (31 reputation)Forum Member (31 reputation)Forum Member (31 reputation)Forum Member (31 reputation)Forum Member (31 reputation)Forum Member (31 reputation)
Group: Forum Members
Posts: 5, Visits: 36

do you think it is possible to build a surfboard with the infusion on both sides and a eps core inside?
Reply Like 4
GO

Merge Selected

Merge into selected topic...



Merge into merge target...



Merge into a specific topic ID...



Submit

Threaded View
Threaded View
infusion surfboard
demy182 - 5 Years Ago
     The eps foams usually used for surfboards are not strong enough to withstand a full vacuum. I'm not saying it's impossible, but certainly complicated and won't give you really an advantage.
SleepingAwake - 5 Years Ago
     Sorry, but vacuum bagging doesn't apply any pressure to a solid material. In principle, the bagging film applies just the same pressure to the foam, that the atmosphere would do without the bagging.....
oekmont - 5 Years Ago
             Yes obviously it doesn't on a solid. The problem is though, that the EPS foam has not perfect closed cells, is inhomogeneous and degasses, so it will crush your foam.
SleepingAwake - 5 Years Ago
     I infused samples with cheap eps in the past. But as it's so cheap I bagged a small sample of foam yesterday. 7mm strong. Sunk in 1/10th mm right away as I applied vacuum and then stayed there for...
oekmont - 5 Years Ago
             you got me curious there and i just ran the same test as well and the foam was completely fine. I was sure i tested that once years ago and crumbled the foam, but i do not know what i did back then.....
SleepingAwake - 5 Years Ago
                 I crushed a windsurf board many years ago. It seemed fine at first but then I left it for some hours and when I came back the whole deck had collapsed. I think maybe if you had a harder foam and/or.....
Fasta - 5 Years Ago
                     let the pump run after that statement and now after a couple of hours the core is quite a bit crumbled. certainly not usable for anything really. So i revise my opinion again and stand by what i said...
SleepingAwake - 5 Years Ago
     My foam is still exactly as before. Pressure is still at 8 mbar. Seems like not every foam, maybe even most foams can take it. Hardness is not a criteria, the foam I used is a wobbly as eps foam can....
oekmont - 5 Years Ago

Similar Topics

Post Quoted Reply
Reading This Topic

Powered by InstantForum 2017-0 Final © 2024
Execution: 0.000. 2 queries. Compression Enabled.
Explore
Messages
Mentions
Search