+x

 

CmCarbon - 4/11/2019 6:55:49 AM

I like how it flows,  self levels and bubble free,  I always had issues same as this post.. I only used the resin on s work bench with heat lamps which kept the temp around 30 degrees,  resin was always kept warm and still I had white lines when sanded,  parts turning milky and pinholes..

+x

 

CmCarbon - 4/6/2019 11:29:26 PM

If your skinning I just use surf board poly resin. .crystal clear, higher temp rating.easy sandandcuresin 10mins if it's warm
. final coat adds me wax additive and seals and cures so it can be sanded

+x

 

Matthieu Libeert - 4/4/2019 7:12:30 AM

when you wet it out with just a bit of water, do you still see the marks? if not you are ok to apply next layers on top. It is probably where you've sanded through different coats 

+x

 

CmCarbon - 4/3/2019 10:14:52 AM

Try pic of any loose resin and sand it back.. then reapply another few coats of resin