I agree this error.

And with my own experience, i can advice you to apply 2 coats of tooling Gel coat, as the first one looks too thin in the angles

You final part looks like there is not enough resin? or maybe some leaks?

Regards,

Seb.

Thanks guys.

I basically followed the video tutorial to the letter. Had no problems making the mould. The finished part was pretty much stuck fast to the mould & has pulled the dried resin off the part & is also stuck the mould itself. I put plenty of PVA on prior to the resin & stuck to the recommended drying times etc  

Ahh well.......back to the drawing board

Cheers

Mick

from the photo's i can only see 1 error and that is in pic 2 at the top left of the piece, the hole needs to be filled with plastercene or wax to stop a 'mechanical lock', as for the finished cf piece, as previously asked a little more info would be helpfull.

could you give us a bit more information on how you did everything in more detail? maybe we can find THE error or some errors

Matthieu Libeert
Founder MAT2 Composites X Sports
website: www.mat2composites.com

I thought I'd covered all bases, studied the tutorial videos & took my time but........................its all gone horribly wrong

What have I done wrong ?

Thanks,  Mick