Hi folks,

I've just joined this forum though I've been reading quite a few of the posts.

I'm preparing to start making my first few parts, mainly resin infused carbon fibre parts for my race motorbikes.

I have a part which is made from 3 relatively flat and simple brackets, and I would like to assemble the plugs on one flat 'mould plate' like the attached image.

My question is, can I lay 3 seperate pieces of carbon - one over each part - with peel ply etc covering the whole mould - or does the infusion process only work properly if there is one piece of carbon covering the whole part set / mould?

I know there's an easy way to find out (try it!) but I'm trying not to waste too much material!

Would appreciate any advice.

Thanks,
Rich