first split mould


first split mould
View
Options
Author
Message
111mattin111
111mattin111
111mattin111
posted 9 Years Ago HOT
Supreme Being (449 reputation)Supreme Being (449 reputation)Supreme Being (449 reputation)Supreme Being (449 reputation)Supreme Being (449 reputation)Supreme Being (449 reputation)Supreme Being (449 reputation)Supreme Being (449 reputation)Supreme Being (449 reputation)
Group: Forum Members
Posts: 67, Visits: 910
I've just done my first split mould nothing complex we but the original part undercuts itself so would cause it to lock

Now my question is do it lay the carbon in side in one piece or in two creating an overlap where the moulds meet

Also where the moulds meet will this not cause an air leak when vaccum bagging? 
http://www.talkcomposites.com/Uploads/Images/f3e9b7f4-952e-43ed-982c-8a30.jpg

http://www.talkcomposites.com/Uploads/Images/c6b2f700-3f50-4760-98d0-e630.jpg
Reply Like 3
GO

Merge Selected

Merge into selected topic...



Merge into merge target...



Merge into a specific topic ID...



Submit

Threaded View
Threaded View
first split mould
111mattin111 - 9 Years Ago
     Looking good. How you lay the cloth is up to you, if you think one piece will go in then fine, if...
VVS - 9 Years Ago
     Thanks i thought some kind of sealant might be used I'm think one piece should be fine the part...
111mattin111 - 9 Years Ago
     Be careful with silicone sealant as VVS mentioned. You want the gasket-maker type RTV that you would...
Hanaldo - 9 Years Ago
     heya, looks like a 300zx nose panel! how are you getting on with carboning the Z? ive seen youve...
delcarlo - 9 Years Ago

Similar Topics

Post Quoted Reply
Reading This Topic

Powered by InstantForum 2017-0 Final © 2025
Execution: 0.000. 2 queries. Compression Enabled.
Explore
Messages
Mentions
Search