When using epoxy or polyester for molds ?

Author	Message
Zorongo	Zorongo posted 10 Years Ago HOT Topic Details
Group: Forum Members Posts: 40, Visits: 330	Hi all. I'm making small size epoxy parts, but sometimes I've made them whith polyester. Room temperature curing, hand lay up with small presure over the laminate (counter mold) I had demolding problems with a polyester mold and someone told me a "rule of thumb": Use polyester molds for polyester parts and epoxy molds for epoxy parts. (I'm actualy using PE molds for epoxy parts without any problem) So, the question is: Whe should I use epoxy molds ? An epoxy mold seems to be better fron the dimensional stability point of view.. It also seems logical to make the molld similar to the part if high temp increases are expected (prepregs, exotherms ?) to reach a similar diatation / contraction on both and avoiding stresses.... Could you please share your experience ? Thanks in advance
	Reply Like 2

Merge into selected topic...

Merge into merge target...

Merge into a specific topic ID...

Zorongo - 10 Years Ago

biker_kev - 10 Years Ago

matthieutje65 - 10 Years Ago

baja_patient - 10 Years Ago

Zorongo - 10 Years Ago

Warren (Staff) - 10 Years Ago

OK, thanks all ! :)

Zorongo - 10 Years Ago

kidpaint - 10 Years Ago

matthieutje65 - 10 Years Ago

fgayford - 10 Years Ago

Jacopo Carbonio - 10 Years Ago

Login
Remember Me Reset Password Resend Validation Email Login	Facebook Google