Hi

I just startet working on a water-clean Epoxi-resin  projekt.    ,  on  a 1 x 2 meter  silicone-mould, 
My problem is the small-fisheying open spots on the rather round-zones of the mould after the firts resin-layer, so I was thinking about doing the second resin-layer with the Easy-composites "clear Epoxy-Gel-Coat",  only to cover-up these small open-fisheyes-holes.   Afterwards a third resin layer would therefore  (hopefully) cover up the entire mould-form

Still--im not shure if this "clear Epoxy-Gel-Coat" REALY is a clear as proclaimed with a layer-high of 2 /3 mm    ????


any users out there with practical Info´s  ?




Jor

No, the EC "clear Epoxy Gelcoat is no totally water clear, it has a slight bluish tinge, and is cloudy in thicknesses above 1 -2 mm...

I have used a product called "PermaCote", this is very clear, but not as clear as acrylic resins. I'm not sure who makes it, but I could probably find out.

What you're trying to do is very difficult, at getting a "perfect result" probably will not happen.

"Sapere Aude"... Dare to KNOW!

The written word is the only truly efficient vehicle for transmitting a complex concept from mind to mind...

103% of all people do not understand statistics...

Do not adjust our mind, theres a fault in reality :-)

As said, what you are doing is very difficult especially on a silicone mould!!

Warren Penalver
Easy Composites / Carbon Mods - Technical Support Assistant

PermaCoat is from "Wessex Resins" in the UK...

"Sapere Aude"... Dare to KNOW!

The written word is the only truly efficient vehicle for transmitting a complex concept from mind to mind...

103% of all people do not understand statistics...

Do not adjust our mind, theres a fault in reality :-)