By eflin1 - 8/17/2014 11:05:41 AM
Hi
I just startet working on a water-clean Epoxi-resin projekt. , on a 1 x 2 meter silicone-mould,
My problem is the small-fisheying open spots on the rather round-zones of the mould after the firts resin-layer, so I was thinking about doing the second resin-layer with the Easy-composites "clear Epoxy-Gel-Coat", only to cover-up these small open-fisheyes-holes. Afterwards a third resin layer would therefore (hopefully) cover up the entire mould-form
Still--im not shure if this "clear Epoxy-Gel-Coat" REALY is a clear as proclaimed with a layer-high of 2 /3 mm ????
any users out there with practical Info´s ?
Jor
|
By Dravis - 8/20/2014 10:12:24 AM
PermaCoat is from "Wessex Resins" in the UK...
|
|