Carbon cloth and right angles

Talk Composites - The Forum for Advanced Composites

Back

Carbon cloth and right angles

Carbon cloth and right angles

Author	Message
joey54321	joey54321 posted 13 Years Ago HOT Topic Details
Group: Forum Members Posts: 6, Visits: 27	Is there a good way to get carbon to go tightly round a right angle? Thanks
	Reply Like 7
Reply
joey54321	joey54321 posted 13 Years Ago HOT Post Details
Group: Forum Members Posts: 6, Visits: 27	I wish I could afford a vacuum pump . I guess I will have to try and get a few right angle to sit on the outside. Thanks for the help guys.
	Reply Like 6

GO

Merge into selected topic...

Merge into merge target...

Merge into a specific topic ID...

Threaded View

Threaded View

Carbon cloth and right angles

joey54321 - 13 Years Ago

Hi. If you use vacuum, it will help. But as always you will need to massage the bag with some tool...

Joe - 13 Years Ago

Where would you place the cuts? It is the the outside I was thinking of and don't have access to a...

joey54321 - 13 Years Ago

without a vacuum pump it will be tough to keep the carbon in position. you could make a (blunt)...

Warren - 13 Years Ago

I wish I could afford a vacuum pump :(. I guess I will have to try and get a few right angle to...

joey54321 - 13 Years Ago

Hey, Dont forget the spray glue, it could really help you in a non-vacuum process. i have no idea...

Joe - 13 Years Ago

Just remember if you cut down the corners, you will need on the structural layers to cut it...

Warren - 13 Years Ago

Warren's right that ProFinish might help you a lot in getting a good cosmetic finish on right angled...

Matt (Staff) - 13 Years Ago

I have just been informed that ourinflatablebed inflater actually has a vacuum/deflate mode. While I...

joey54321 - 13 Years Ago

Hi Joey, Your right in thinking that an air-bed deflator would not have anything like the level of...

Paul (Staff) - 13 Years Ago

Sorry to bump an old thread.... But... this was made via wetlay, using no cuts nor no vac setup,...

CarbonMike - 13 Years Ago

Hi Mike, You've done well there, especially considering it's a 650g cloth you're using which is...

Matt (Staff) - 13 Years Ago

[quote][b]Matt (Staff) (17/06/2012)[/b][hr]Hi Mike, You've done well there, especially considering...

CarbonMike - 13 Years Ago

Similar Topics

Post Quoted Reply

Reading This Topic

Login
Remember Me Reset Password Resend Validation Email Login	Facebook Google

Explore

Messages

Mentions

Search