I'm trying to speed up my infusion work process - normally when the resin infusion is complete, I turn off the vacuum. Then leave overnight, then post cure.... I could transfer to the oven straight after turning off vac - any suggested ramps for this to achieve fast cure and 60-70 degree post cure?

Thanks,
James

If the part is purely cosmetic it may be worth trying a Urethayle Acrylate resin as it is possible to add 1-2% of cobalt to the resin before adding the catalyst ( DO NOT MIX COBALT WITH THE HARDENER, IT WILL EXPLODE ). Often these have a much lower viscosity than epoxies and subsequently infuse much easier. The cure times depending on the size of the part can be very quick indeed.