+x Lester Populaire - 1/5/2021 2:35:22 PM+x Massimiliano - 1/5/2021 7:36:40 AMSo I did it and I am not dissatisfied with the result.I have given a try to the MTI hose and very happy with it, but the resin inlet spiral left a bad print on the part: seems like the carbon under the spiral is more compacted than the rest. And the immediate surrounding of the spiral is a little raised.Talking about a fraction of millimeter, but still very visible.How can I prevent this in the future?Make sure you have enough bag above the spiral hose, then once the infusion is finished you pull the hose up into the fold of the vacuum bag.Either that or infuse from side to side if the geometry and part size allows for this.
+x Massimiliano - 1/5/2021 7:36:40 AMSo I did it and I am not dissatisfied with the result.I have given a try to the MTI hose and very happy with it, but the resin inlet spiral left a bad print on the part: seems like the carbon under the spiral is more compacted than the rest. And the immediate surrounding of the spiral is a little raised.Talking about a fraction of millimeter, but still very visible.How can I prevent this in the future?