Hello, I have been working many years with the unimould system but now I going over to the High Temp mould system for the xpreg prepregs . 

I am laminating the mould with 1 layer 100G woven glass than 1 layer 280G woven glass after this I let it set to gell 
han I put 2 layers of 400G woven glass and stop with 1 layer 100G glass to finish.

Are this enough layers for the moulds ? 
And also "why I dont like epoxy " is there a way to not get the air coming up to the high spots in the moulds . 
I make superbike fairings and they got alot of shard , round edges and when the glass and epoxy is just layed down , I dont got any airbubbles but after time the wil show up at high spots . 

This is why I first put the 100G and 280G and leave them to gell first . 

Looks good a lot of parts there.what cure cycle did you use on unimold and any issues.i think your going to like xpreg tooling a it more work.

I used the same on the unimould as on the high temp epoxypost cured them the same and for the prepreg  . 4H soak at 70° 1H post cured the mould the same 
Only issu was few pinholes where you put the bolts thru the fender when mounting on the bike . 
But thats more a bagging error from myself with the new parts in the high temp epoxy I had the same on 2 of the 4 parts just looking to get the bag down arround thos spots is sometimes a problem .