Vents location ?

Author	Message
Classicarbon	C Classicarbon posted 6 Years Ago HOT Topic Details
C Group: Forum Members Posts: 86, Visits: 639	What's the best way to Mark those vents? I want to use flash tape to blank them for making mould,but is there way to Mark them up later on on carbon? Should I just do not use flash tape but use wax instead?
	Reply Like 3
Warren (Staff)	Warren (Staff) posted 6 Years Ago HOT Post Details
Group: Administrators Posts: 2.5K, Visits: 8.5K	Hi, You could put some tape or similar on the back, then fill in from the front using filleting wax. Press the wax down slightly so it slightly recesses and you should then see the vent outline on the mould and part surface giving you a line to cut to. Warren Penalver Easy Composites / Carbon Mods - Technical Support Assistant
	Reply Like 3
Classicarbon	C Classicarbon posted 6 Years Ago HOT Post Details
C Group: Forum Members Posts: 86, Visits: 639	+x Warren (Staff) - 8/8/2019 8:49:10 AM Hi, You could put some tape or similar on the back, then fill in from the front using filleting wax. Press the wax down slightly so it slightly recesses and you should then see the vent outline on the mould and part surface giving you a line to cut to. Aaa thought so,just mix the sides where to stick tape. Great thanks
	Reply Like 2