Talk Composites - The Forum for Advanced Composites

Vents location ?

http://www.talkcomposites.com/Topic33519.aspx

By Classicarbon - 8/8/2019 7:39:34 AM

What's the best way to Mark those vents?
I want to use flash tape to blank them for making mould,but is there way to Mark them up later on on carbon? 
Should I just do not use flash tape but  use wax instead?
By Classicarbon - 8/8/2019 9:17:05 AM

 
Warren (Staff) - 8/8/2019 8:49:10 AM
Hi,
You could put some tape or similar on the back, then fill in from the front using filleting wax.  Press the wax down slightly so it slightly recesses and you should then see the vent outline on the mould and part surface giving you a line to cut to.

Aaa thought so,just mix the sides where to stick tape. Great thanks